Pulse Generation

Generate a Short pulse every 1 Sec

Solution :-

Pulse generation using timer of 1 Sec.

Above fig. shows ladder dig. for generation of pulse after every 1 sec.
in first rung of program start NO contact is connected in series with timers Done bit NC contact and a TON timer with a preset value of 1 sec.
In second rung of the program timers DN bit NO contact is connected in series with the output O:2/0 coil
when start button is pressed output gets on for 1 sec of time and after 1 sec DN bit of the timer gets on which will reset the timer and also output gets off for some time.

Comments

HOW TO DOWNLOAD AND INSTALL WONDERWARE FOR WINDOWS 8,7,10.

##You can Download a ZIP file of the software From Below link. https://drive.google.com/file/d/159y8W0c_bw0vvf1DNDQ08_QsLZ9h2Tb1/view?usp=sharing 1 ) You Can Also Watch a Video Tutorial of it below. 2) You can also read out steps from below :-

Block Diagram of PLC.

Hardware / Block diagram of PLC. Above fig. shows the block diagram of PLC.

Timer instruction

In mitsubishi PLC Gx-Developer programming software we have total 512 timers From T0 - T511. These timers are categorized into 5 groups depending upon the time base and type of timer as :- T0 - T199 timers works as Done bit of TON timer (time base-100ms). T200 - T245 timers works as Done bit of TON timer (time base-10 ms). T246 - T249 timers works as Done bit of retentive timer (time base- 1 ms). T250 - T255 timers works as Done bit of retentive timer (time base-100 ms). T256 - T511 timers works as Done bit of TON timer (time base- 1 ms). You may be aware of the working of the TON timer and RTO timer, which works similarly of TON and Retentive timers in AB PLC, the only difference is you only get the done bit of timers in mitsubishi PLC. To enter proper preset value to the timers of various time bases we need to convert the seconds into the respective time bases. Below table shows the conversion of pre-set values into the respective time bases. We can use the sa...

blog2code

Search This Blog